View this product description in Norwegian.
The Ampetronic ILR3+ hearing loop tester / receiver is designed to perform the same induction receiver function as the ILR3 whilst also providing the added capability to check that the induction loop is functioning correctly.
When an induction loop is installed the venue manager or staff should always be supplied with at least one instrument that allows them to regularly monitor the system performance. The IR3+ performs this task without the added cost and complexity of a Field Strength Meter. It is simple and highly cost effective, and meets the requirements of the international loop performance Standard, IEC60118-4.
No technical skills are required to perform the basic checks, which allow an operator to listen to the system through headphones, and check that the sound level provided by the loop is sufficient.
The loop checking system comes with an easy to follow procedure for checking any loop system.
Low Cut Filter
The ILR3 incorporates a low cut filter. Switching the low cut filter on attenuates the low frequency (bass) components of the signal emulating a typical hearing aid response and helps reduce the annoying ‘buzz’ caused by some AC power circuits.
For best reception in general use and where there is no low frequency interference, the ILR3 should be used with the ‘flat’ frequency
response selected.
Specification
- Frequency response: Standard: Flat 85Hz – 6kHz ± 0.5dB Low Cut: 400Hz – 6kHz – 3dB (similar to hearing aid)
- Output power distortion: >100mW into 16O load
- Battery powered: 2 x Alkaline AA (included)
- Battery life: >100 hours with Alkaline batteries
- Indication: ‘Good’ 0dB Green LED 400mA/m rms with sine ‘Okay’ -6dB Amber LED 400mA/m rms with sine
- PhysicalDimensions: width 62mm, depth 26mm, height 112mm
- Temperature range: IP20 : 20 to 90% relative humidity, -10 to 45ºC
Accessories
- Stereo headphones impedance 32O per side (included)